The Taylor-Made Detail.



This is the most comprehensive and in depth service I offer for motorcycles.
Duration 30-50 hours depending on condition. And includes the following;

•Fairing panel removal (where applicable)
 Cover all electrical items and connections
•pre rinse to remove the lose dirt and  contamination
•multiple degreasing stages around chain, sprockets, rear suspension and linkages
•citrus prewash, rinse
•snowfoam prewash and allow to dwell before rinsing
•Engine clean and degrease
•super soft detailing brushes used in conjunction with either citrus wash or apc to remove contamination from panel gaps and vents etc, rinsed
•wheels and callipers cleaned with appropriate cleaners and brushes
• 2 bucket, safe wash and rinse
• 3 stage decontamination...tar removal, fallout removal and clay bar the paintwork
•rinse and re snowfoam before a final rinse
•any panels removed are cleaned inside to remove and grease or tar build up
•blown dry with warm filtered air
•paint inspection and then perform test areas to see how the paint will react to correction
•2/3 stage paint correction to remove swirls and light scratches, wheels also done.
With full ipa wipe down (isopropyl alcohol) in between each stage
•full acf50 treatment to engine and hard to reach areas, rear suspension etc
Bolts, screw heads etc also done with use of fine artist brush and acf50 or I offer a ceramic alternative for higher protection.
•panels refitted
•All surfaces to be coated are panel wiped down to ensure no residues remain prior to coatings.
•All panels, wheels, frame, swingarm etc are coated with Ultimaxx ceramic coatings
•Matte plastic trims also coated with appropriate vinyl coatings.
•coatings allowed to cure for a minimum of 12 hours.

•chain and all pivot points relubed
•oil levels, coolant levels etc checked
•chain adjusted if required
•tyre pressure checked and adjusted where necessary


Only available at my workshop due to timescale and work involved.
Starting at £200 for the 2 year ceramic coating and acf50 applied to bolts and fasteners
£250 for the 4 year coating and ceramic coatings applied to bolts and fasteners